Echtholz

joined 1 year ago
 

Eben beim Warten auf den IC kam auf dem Gleis gegenüber eine einzelne Lok an - recht sauber, der seitliche Kühler beleuchtet. Die Lackierung lässt darauf schliessen dass dieses Exemplar zum ziehen des ICE L gedacht ist.

 

Also wenn sich der Start noch weiter verschiebt kann man so langsam an "10 years after" T-Shirts denken :/

 

Stuttgart HBF, Gleis 8, Abschnitt F

 

Stuttgart HBF, Gleis 8, Abschnitt F

 

Es ist immer wieder das Gleiche:

ein Schaden an einer Weiche.

Dazu kommt noch - und das ist Fatal:

ein kaputtes Signal.

Deshalb hat es - was für ein Scheiß -

auf der ganzen Strecke nur noch ein Gleis!

1
Ausbaldowern (www.presseportal.de)
 

Mögliches Ausbaldowern eines Wohnhauses Zwei bislang unbekannte Personen versuchten möglicherweise [...] ein Wohnhaus in der Bahnhofstraße in Landau-Dammheim auszubaldowern.

1
Ausbaldowern (www.presseportal.de)
 

Mögliches Ausbaldowern eines Wohnhauses Zwei bislang unbekannte Personen versuchten möglicherweise [...] ein Wohnhaus in der Bahnhofstraße in Landau-Dammheim auszubaldowern.

 

Nicht zu verwechseln mit dem Fabulant!

 
[–] Echtholz@feddit.org 0 points 11 months ago* (last edited 11 months ago)

I recommend using a touring/mountain/road bike with the same crank length than the Brompton (175mm) and check the development of the gear you use on the steepest incline you usually ride on your Brompton. Then see how you can achive this development on the Brompton. On a mountain bike you normally have a development of 1.7m or lower on the lowest gear. This is not possible on the Brompton without further modifications - the limit is 1.95m with a 39T chainring with a 17T sprocket .

BTW: I use a 42T chainring that results in a development of 2.38m in combination with the 15T sprocket.

recommended reading/viewing: https://sheldonbrown.com/adv-cycling/gainratios.pdf https://www.youtube.com/watch?v=-Q9wd8Ewlec

[–] Echtholz@feddit.org 0 points 11 months ago (2 children)

Have a look at the "ritzelrechner.de" - It also covers various Brompton configurations: https://ritzelrechner.de/?GR=BWR6&KB=50&RZ=13%2C16&UF=1330&TF=75&SL=2.6&UN=KMH&DV=development&GR2=BWR6&KB2=42&RZ2=12%2C15&UF2=1330 Imho, for 6 speed Bromptons, 12/15T sprockets is a good combination because it gives you a constant 25% spread between gears.

view more: next ›