Hi DIY!
My headphones of many years recently broke. My first response was to attempt to glue them back together with super glue (ethyl 2-cyanoacrylate) however that didn't seem to hold. Not even a little bit.
I then did a bit of searching and found that Sony often use ABS plastic in headphone manufacture, so presumably these are ABS. I then read super glue should work okay on ABS, however there seemed to be no bonding happening at all.
Do any of you have any tips for the best kind of glue or epoxy to bond these plastic parts back together and get the music flowing again?
I plan on wrapping the joints in thread afterwards, for additional durability. But first I need to get them bonded.
Speaking of physical reinforcement, when my headphones broke in a very similar way I was able to use cable ties to secure them back together. Ugly but it worked.
The headphones I currently use (on my head right now) also have physical reinforcement, but instead of zip ties it's just a thin tensile wire I had lying around. (If you mean ye olde twist-ties like in grocery store produce sections, then that's close!) Tied it around a cylinder piece that broke off that holds a rotatable insert, superglue, and lots of extra wraps encased in superglue... and it's perfect! ... outside of where I was dumb and got glue between the rotatable faces and now it binds up a bit, but otherwise great. Replacement parts would've been like $35+.
... I guess all of that is to say, physical reinforcement is excellent when it's adding strength as opposed to replacing strength! (similar to OP, the superglue is a bit brittle for a one to one toughness fix).