Mechanical Keyboards

13992 readers

3 users here now

Are you addicted to the clicking sounds of your beautiful and impressive mechanical keyboard?
If so, this community is for you!

Here you can discuss everything about mechanical keyboards (and only mechanical keyboards).

Banner by Jay Zhang on Unsplash

founded 6 years ago

Trying to flash QMK/VIA firmware - HELP! I think I might have killed my keyb! (feddit.uk)

submitted 1 year ago by i_am_not_a_robot@feddit.uk to c/mechanicalkeyboards@lemmy.ml

3 comments fedilink hide all child comments

I bought a cheap Durgod Hades with the intention of sticking the QMK/VIA firmware on it.

First issue was getting it into the bootloader - the instructions didn't seem to be working, so I was trying different connection points and implements until it finally kicked into life. In doing that I suspect I may have killed the STM32... but I'm not sure.

Using dfu-util I've tried :unprotect:force and :mass-erase:force to try and recover it, and also downloaded STM32Cube to see if I have more luck with that.

dfu-util, no matter what I do, hangs at the erase point 0%. Eventually it times out with an error.

STM32Cube connects to the keyboard but complains it's in read-only or reset held. If I try again with the suggested Read Unprotect option it says I need to power off and power on the device, and the cycle continues.

So I think I've somehow bust it, is there anything else I can try before admitting defeat and getting another one?

you are viewing a single comment's thread
view the rest of the comments

[–] i_am_not_a_robot@feddit.uk 0 points 10 months ago (1 children)

Thanks, it wasn't running the default after unplugging and replugging. I ended up replacing it, although I still have the dead one as I'm not sure what to do with it!

[–] Metafalls_@beehaw.org 0 points 10 months ago

Oh, that's rather unfortunate :(

Here's hoping the replacement works swimmingly