this post was submitted on 08 Aug 2025
1 points (100.0% liked)

Homebrewing - Beer, Mead, Wine, Cider

2971 readers
8 users here now

A community dedicated to homebrewing beer, mead, wine, cider and everything in between. If it ferments, bring it over here.

Share recipes, ideas, ask for feedback or just advice.


Some starting points for beginners:

Introduction to Beer Brewing

A basic mead primer

Quick and diry guide to fermenting fruit - cider and wine

Brewing software


founded 3 years ago
MODERATORS
 

I feel like I haven’t posted here in a while… basically I decided to take a break from drinking and thus home brewing for a bit. I want to get back into meme spirits, and I also want to make a 0 oxygen beer from ferment to filter to serving, but for now I made a berry wine for the girlfriend from some Aldi frozen fruit. This has been sitting in the fermenter on the fruit for a good 3 months (started it just before my break from alcohol) and then I moved it into a keg, no cold crashing or anything. I then ran it through a 5 micron filter and then a 1 micron filter just to see how it went, I gotta say, it turned out great. I was expecting the filter to clog but it went through like a champ. I also then wanted to try pasteurizing it in the keg using my mash and boil to see if I get some delicious glue and rubber in my mashing vessel but I didn’t! I back sweetened the wine and haven’t had any re-fermentation happen after a few weeks, so project fuck around and find out was a success. I might end up retrying a milk wine again (last one had a few tiny cheese curds floating in it that turned off most people from it) and I definitely want to try making a spicy imperial stout, but for now, I’ve gotta buy wine bottles or give out samples of this wine until my keg is empty.

you are viewing a single comment's thread
view the rest of the comments
[–] poleslav@lemmy.world 0 points 10 months ago

I imagine it should be fine for the filter material and the plastic that it goes into. I pasteurized in my keg at 68 Celsius for an hour by tossing it into my electric boiling pot. I was expecting the glue on it to melt but it held up just fine. The plastic housing of my filter is also pretty thick, though I haven’t heated it up yet but I don’t see why it wouldn’t work!